Sensors
Speed sensors
The speed sensors developed by VISPIRON ROTEC are designed for non-contact measurements of the rotational speed of a gear wheel. A ferromagnetic encoder wheel can thus be scanned. The sensors deliver high-quality signals across a broad range of requirements.
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
Maximum tooth frequency
20 kHz (with DSA)
Gearing
- ferromagnetic target wheel
- Module 0,6 to 2,4
- Pitch 1,9 mm to 7,7 mm
Sensing gap
0,5-2x modul [mm]
Sensor type
Passive, requirement of accompanying electronic unit (DSA)
Temperature range speed sensors
-15 °C to +100 °C
Temperature range high temperature sensors
-40 °C to +125 °C (+140°C temporarily in measuring mode)
Housing
Stainless steel M10x1 outer thread
Pins
- Integrated cable with Lemo 4-pin connector (type A)
- Separate Lemo 4-pol connector to Lemo 3-pol connector (type B and c)
Type A
Technical drawing
Speed sensor
Thread length 30 / 60 / 90 mm, with integrated cable, length 1 m
4-fold speed sensor
The 4-fold speed sensor is used with the associated electronic unit to detect the direction of rotation of a gear wheel (e.g. such as start/stopp attempts).
Thread length 60 mm, with integrated cable, length 2 m
Type B
Technical drawing
Speed sensor
Thread length 30 / 60 / 90 mm, incl. cable (0°) / (90°)
High temperature sensor
Thread length 30 / 60 / 90 mm
Type C
Technical drawing
Speed sensor
Thread length 30 / 60 mm, incl. cable (0°) / (90°)
Thread length 90 mm, incl. cable (0°)
High temperature sensor
Thread length 30 / 60 / 90 mm
Laser sensors
You can make speed measurements using the reflex method with our powerful laser cable in combination with the laser tachometer. Depending on requirements, a line disc or a dashed tape is scanned.
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
Recommended line width
1 mm to 80 mm distance of the laser head
Length of laser cable
5 m
Minimal line width
0,15 mm (under optimal conditions)
Housing
Stainless steel
External thread
M10x1
Accessories
90° mirror
Technical drawing
